Your ATEM switcher defaults to a fixed IP address of 192.168.10.240 when shipped and, by using the ATEM Setup Utility, you can customize the IP address for your custom network configuration.
You will need to manually set the IP address for the switcher chassis as well as all control panels to match your network IP address range. Information on how to do this is available in the next section. If you’re more technically minded and want to connect your ATEM switcher to your existing network, then you will need to change the network settings on your ATEM switcher and control panel. Now when you run your ATEM Software Control you should see the buttons on the control tab light up and show the switcher state after a slight pause. In the network settings on your computer, enable ethernet, and set the IP address setting to manual. Now the computer will talk via your panel to the switcher, and both the hardware panel and this software control panel can be operated in parallel. If you have a hardware panel installed, and already have this connected to your ATEM, then plug your computer into the second ethernet port on your hardware panel instead. lse&os=winĬonnect an Ethernet cable from the chassis ethernet port labeled Switcher Control to the Ethernet port of your computer. The New ATEM SDI Pro ISO is the complete solution to fast and easy live production switchers. Start by connecting directly from your computer to your TVS to make sure that the software are installed OK and everything are working correctly. The switchers ISO label means you can individually record each of the eight input videos as an MP4, as well as the program output via one of the USB Type-C. You must use a different IP for your computer not the same as the TVS chassis.
0 kommentar(er)
